====================================================================================
Installation instructions:
--------------------------

1. Make a copy of EEE Data Acquisition.ini file to keep setup configuration;

2. Uninstall EEE Project software;

3. Install CAENVMELib Library v2.30 or later (check http://www.caen.it/csite/CaenProd.jsp?parent=38&idmod=689);

4. Upgrade CAEN USB-VME Bridge driver to latest version (check http://www.caen.it/csite/CaenProd.jsp?parent=11&idmod=417);

5. Install EEE Project software; LabVIEW Run-Time Engine included in EEE Data Acquisition installer, and will be installed if necessary;

6. Open folder with EEE Data Acquisition program;

7. Replace default EEE Data Acquisition.ini file with previously saved copy to restore setup configuration;

8. On the first run of EEE Data Acquisition program make sure that all parameters are correct


NOTE: Starting from v1.7.x EEE Project software requires special CAEN TDC V1190 firmware Rev0.7 or higher. Please check firmware on each TDC in the system and update if necessary.
NOTE: For EEE Combo card please select proper GPS type and check VME address. Use corresponding tester program if necessary.

In case of software installation problem please contact Raman Zuyeuski (Raman.Zuyeuski@cern.ch) or Crispin Williams (Crispin.Williams@cern.ch).

====================================================================================
Version 3.0.0
--------------

1. EEE Project Software supports both 32-bit (x86) and 64-bit (64) versions of Windows, just download proper package;

2. EEE Project Software recompiled under LabVIEW 2017 for optimisation and stability;

2. LabVIEW 2017 Run-Time Engine included in all EEE installers;

3. All programs checked for compatibility with Windows 10 (x86/64);

4. EEE Data Acquisition:
- Added support for EEE Combo card;
- Minor decoratin changes.

====================================================================================